Linux version 2.4.31 (root@hugues.lepesant.com) (gcc version 2.95.4 20011002 (Debian prerelease)) #1 Mon Jun 27 17:04:36 CEST 2005
BIOS-provided physical RAM map:
 BIOS-e801: 0000000000000000 - 000000000009f000 (usable)
 BIOS-e801: 0000000000100000 - 0000000020000000 (usable)
512MB LOWMEM available.
On node 0 totalpages: 131072
zone(0): 4096 pages.
zone(1): 126976 pages.
zone(2): 0 pages.
DMI not present.
Kernel command line: console=ttyS0,115200 debug ip=off 
Initializing CPU#0
Detected 298.807 MHz processor.
Calibrating delay loop... 596.37 BogoMIPS
Memory: 516692k/524288k available (999k kernel code, 7208k reserved, 288k data, 72k init, 0k highmem)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount cache hash table entries: 512 (order: 0, 4096 bytes)
Buffer cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
CPU: L1 I Cache: 32K (32 bytes/line), D cache 32K (32 bytes/line)
CPU:     After generic, caps: 008021bf 808029bf 00000000 00000002
CPU:             Common caps: 008021bf 808029bf 00000000 00000002
CPU: AMD-K6(tm) 3D processor stepping 0c
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
mtrr: v1.40 (20010327) Richard Gooch (rgooch@atnf.csiro.au)
mtrr: detected mtrr type: AMD K6
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: Probing PCI hardware (bus 00)
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
VFS: Disk quotas vdquot_6.5.1
Journalled Block Device driver loaded
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Real Time Clock Driver v1.10f
Non-volatile memory driver v1.2
loop: loaded (max 8 devices)
eepro100.c:v1.09j-t 9/29/99 Donald Becker http://www.scyld.com/network/eepro100.html
eepro100.c: $Revision: 1.36 $ 2000/11/17 Modified by Andrey V. Savochkin  and others
eth0: Invalid EEPROM checksum 0xc803, check settings before activating this device!
eth0: PCI device 8086:1209, 00:10:E0:01:23:B6, IRQ 11.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 000000-000, Physical connectors present:
  Primary interface chip None PHY #0.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0xdbd8681d).
  Receiver lock-up workaround activated.
eth1: Invalid EEPROM checksum 0xcf03, check settings before activating this device!
eth1: PCI device 8086:1209, 00:10:E0:01:23:BD, IRQ 10.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 000000-000, Physical connectors present:
  Primary interface chip None PHY #0.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0xdbd8681d).
  Receiver lock-up workaround activated.
eth2: PCI device 8086:1229, 00:90:27:2C:DB:1F, IRQ 9.
  Receiver lock-up bug exists -- enabling work-around.
  Board assembly 689661-004, Physical connectors present: RJ45
  Primary interface chip i82555 PHY #1.
  General self-test: passed.
  Serial sub-system self-test: passed.
  Internal registers self-test: passed.
  ROM checksum self-test: passed (0x24c9f043).
  Receiver lock-up workaround activated.
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ALI15X3: IDE controller at PCI slot 00:0f.0
ALI15X3: chipset revision 193
ALI15X3: 100% native mode on irq 14
    ide0: BM-DMA at 0xfdd0-0xfdd7, BIOS settings: hda:DMA, hdb:DMA
    ide1: BM-DMA at 0xfdd8-0xfddf, BIOS settings: hdc:DMA, hdd:DMA
hda: ST313620A, ATA DISK drive
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
blk: queue c0279200, I/O limit 4095Mb (mask 0xffffffff)
ide0 at 0xfdf8-0xfdff,0xfdf6 on irq 14
hda: attached ide-disk driver.
hda: 26520480 sectors (13578 MB) w/512KiB Cache, CHS=26310/16/63, UDMA(33)
Partition check:
 hda: [PTBL] [1650/255/63] hda1 hda2 hda3 hda4
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 131072 bind 65536)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 72k freed
Adding Swap: 498004k swap-space (priority -1)
usb.c: registered new driver hub
usb-ohci.c: USB OHCI at membase 0xe0855000, IRQ 6
usb-ohci.c: usb-00:02.0, PCI device 10b9:5237
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
Linux video capture interface: v1.00
V4L-Driver for Vision CPiA based cameras v0.8.5
USB driver for Vision CPiA based cameras v0.8.5
usb.c: registered new driver cpia